Display Options



The "Display" settings control the general display format of PingPlotter’s graphs, including scaling, coloring, and other general values.

Color HOP column by speed

If you want to minimize on-screen color, turning this off will hide the green, yellow and red background color on the hop (first) column.

Color graph background

Some 256 color graphics drivers might not look very good with the colors on the graph.  Turn off this switch to use a non-color background.

Warning and Critical speed limits

Changing these values sets the Green / Yellow / Red threshold for the graphs.  This is dependant on your expected performance.  For a modem, 200 ms might be quite good, while for a T1, it could be considered bad.

Draw X on graph for current sample

When examining current data, sometimes its handy to graph the most recent sample collected.  Turn this on to see that.

Draw line to show Min/Max Range

When showing just a few samples, this can be really handy to see the range of latencies.  As you increase your window, though, a single bad sample can make this line stretch the scale of the graph.

Graph Scale

Normally, setting the graph scale to automatic works pretty well.  Sometimes, you might get a few samples *way* out of range, though, that stretches the scale.  This is especially likely as you increase the value for samples to include.

Packet Loss

Most often, graphing the packet loss is a handy, easy way to see lost samples.  30% seems to work great for highlighting just the right of loss in most cases, but you’re certainly going to run into cases where you want to change this to something lower (as low as 1) or higher (any number is valid – even over 100).